Here are the steps to check, clean or replace you Emblaser Pro exhaust fans.
Please follow them carefully and contact us if you run into any problems: help@darklylabs.com
Tools Needed:
- 2x Replacement Exhaust Fans: ORDER HERE
- Torx T10 Screwdriver
- Hex 2.5mm tool
Step 1:
*** Make sure you turn your machine off and unplug the power before proceeding. ***
Step 2:
Using Torx T10 screwdriver, remove the 5 screws holding the exhaust side cover in place.



Step 3:
Locate the 2 fan plugs and carefully unplug them.

Step 4
Using the Hex 2.5 Tool, remove the 4 screws holding the fans in place.
Each screw has a small washer. Be careful to not loose them.


Step 5
The fans can now be removed for cleaning or replacement.
To re-install, follow the above steps in reverse.
